Skip to content

Landscaping

Mulch and Rock Calculator: How Much Do You Need?

A 10 x 12-foot bed (120 square feet) mulched 3 inches deep takes about 1.11 cubic yards, which is roughly 15 bags of 2 cubic feet. The same footprint in 2-inch rock takes about 0.74 cubic yards, or close to 1 ton at typical gravel density. Every mulch and rock calculator runs on the same arithmetic, so you can check any online tool against it in about a minute.

The one formula behind every calculator

Square feet × depth in inches ÷ 324 = cubic yards. The 324 comes from a cubic yard being 27 cubic feet, and 27 × 12 inches gives 324 square feet at 1 inch deep. Coverage halves each time depth doubles: one cubic yard spreads over 162 square feet at 2 inches, 108 at 3 inches and 81 at 4 inches.

Start with your tape measure. Multiply length by width for each rectangular zone, and for curved beds split the shape into rectangles and add them up. A circle, such as a ring around a fire pit, is π × (diameter ÷ 2)². Do the math zone by zone, then total the yardage, rather than averaging dimensions across the whole patio.

Depth changes the order

Mulch depth depends on the material and the job. University extension guidance notes that many chipped or shredded hardwood mulches go down 2 to 4 inches thick. Some extension guidance is more specific: bark should stay under about 3 inches, while wood chips are commonly laid 3 to 4 inches deep. Fine mulch such as shredded leaves or grass clippings should stay near 2 inches, because thicker layers mat down and shed water instead of absorbing it.

Rock runs thinner. Two inches suits decorative beds and paths, and angular gravel under a patio surface usually goes 2 to 3 inches deep. Driveways want 4 to 6 inches, usually in two layers, but that rarely applies to a patio border. Small gravel used as plant mulch is often spread only about 1 inch deep.

On a 120-square-foot bed, the gap between depths adds up fast:

Depth Cubic yards for 120 sq ft Bags of mulch (2 cu ft) Tons of gravel (1.4 tons/yd³)
2 in 0.74 10 1.04
3 in 1.11 15 1.56
4 in 1.48 20 2.07

Going from 2 to 4 inches doubles the material. If a rock bed will hold a few plants, one inch of depth can mean about half a ton of difference in your order.

Yards, bags and tons

Bagged mulch is labeled in cubic feet, and bulk mulch is sold by the cubic yard. A yard holds 27 cubic feet, so it equals 13.5 bags of 2 cubic feet or 9 bags of 3 cubic feet. For bags, multiply square feet by depth in inches, divide by 12, then divide by the bag size. A 100-square-foot bed at 3 inches comes out to 25 cubic feet, or 13 two-cubic-foot bags. Bags make sense for small beds, and bulk usually wins once you pass roughly 500 square feet.

Rock is where the weight conversion matters. Yards give you volume, but quarries and landscape suppliers usually sell by the ton. Multiply cubic yards by the material’s density in tons per cubic yard. Typical figures run:

  • Landscape gravel: 1.25 to 1.35
  • Pea gravel and washed gravel: 1.4 to 1.6
  • River rock: 1.4 to 1.75
  • Lava rock: 1.2 to 1.4
  • Decomposed granite: 1.35 to 1.5

One ton of standard gravel at 1.4 tons per cubic yard covers about 116 square feet at 2 inches, 77 at 3 inches and 58 at 4 inches. The old rule that a ton covers 100 square feet at 2 inches assumes a heavier stone near 1.6 tons per yard. Ask the supplier for the actual density of the rock you are buying, since river rock can swing the tonnage by 20 percent or more.

Padding the order

Add 10 percent for spillage, settling and uneven ground. For curved beds, 15 to 20 percent is safer. If the rock will form a base that compacts, such as a dense-graded base under pavers, order about 25 percent more so it settles to the depth you planned. Clean washed stone does not compact, so it needs only the standard margin.

Run the example once more with padding. The 120-square-foot mulch bed at 3 inches comes to 1.11 yards, which becomes about 1.2 yards with the 10 percent margin. In bags, that is 17 of the 2-cubic-foot size instead of 15. The 2-inch rock bed goes from 1.04 tons to roughly 1.15, and suppliers typically deliver in half-ton increments, so you would order 1.5 tons or ask for a precise scale weight on the ticket.

Keep mulch 2 to 3 inches off woody stems and tree trunks, and 6 to 12 inches off house walls, according to Clemson Extension. Subtract those gaps from your square footage before you calculate, or you will order mulch that has nowhere legal to go.

The Patio Guide answers common questions about patios, decks, and outdoor living, one topic at a time.